Garage Door Repair in Malden, WA

A standard spring is rated around 10,000 cycles, which is roughly seven to ten years for an average household. Open and close the door four or more times a day and that drops sharply. High-cycle springs are worth the small upgrade if your door works hard.

Yes. We service rolling steel, coiling and sectional overhead doors for shops, warehouses, fleet bays and loading docks throughout Malden, including high-cycle spring and operator upgrades and scheduled preventive maintenance.

We do both. That covers insulated steel, carriage house, modern flush and glass panel doors, plus belt-drive, chain-drive and wall-mount openers with Wi-Fi and battery backup. We measure, quote, install, balance and haul the old door away.

Broken torsion springs, by a wide margin, followed by frayed cables and worn rollers. All three come from the same source: thousands of cycles of metal fatigue that give no warning until the part lets go.

It depends on the part that failed. A tune-up or sensor realignment sits at the low end, roller and cable work in the middle, and torsion spring replacement or a new opener at the higher end. You get a firm, itemised price in Malden before any work begins, and that number does not move once the job starts.

Look at the springs above the door — a clean gap in the coil means a broken spring and the door should not be forced. Otherwise check that the opener has power, the wall button works, the photo-eye sensors at floor level are aligned and clean, and the door is not locked or disengaged from the trolley. If the door is heavy to lift by hand, stop and call.