Garage Door Tune-Up & Maintenance in Lopez Island, WA

Usually a safety sensor issue or a down-force setting that is too sensitive. Sometimes it is a real obstruction, a worn roller binding in the track, or a door that has fallen out of balance. All four are quick to diagnose in person.

Keep the photo-eye sensors clean and aligned, run the auto-reverse test with a roll of paper towel on the floor, and listen for changes in noise. Avoid spraying lubricant on the track itself — the rollers need to roll, not slide.

Look at the springs above the door — a clean gap in the coil means a broken spring and the door should not be forced. Otherwise check that the opener has power, the wall button works, the photo-eye sensors at floor level are aligned and clean, and the door is not locked or disengaged from the trolley. If the door is heavy to lift by hand, stop and call.

We do both. That covers insulated steel, carriage house, modern flush and glass panel doors, plus belt-drive, chain-drive and wall-mount openers with Wi-Fi and battery backup. We measure, quote, install, balance and haul the old door away.

A standard spring is rated around 10,000 cycles, which is roughly seven to ten years for an average household. Open and close the door four or more times a day and that drops sharply. High-cycle springs are worth the small upgrade if your door works hard.

Yes, genuinely. A torsion spring holds enough stored energy to cause serious injury when it releases, and winding bars slip easily. This is one of the few garage door jobs where the DIY route is not worth the risk.