Garage Door Tune-Up & Maintenance in Skamokawa, WA

Keep the photo-eye sensors clean and aligned, run the auto-reverse test with a roll of paper towel on the floor, and listen for changes in noise. Avoid spraying lubricant on the track itself — the rollers need to roll, not slide.

It depends on the part that failed. A tune-up or sensor realignment sits at the low end, roller and cable work in the middle, and torsion spring replacement or a new opener at the higher end. You get a firm, itemised price in Skamokawa before any work begins, and that number does not move once the job starts.

We do both. That covers insulated steel, carriage house, modern flush and glass panel doors, plus belt-drive, chain-drive and wall-mount openers with Wi-Fi and battery backup. We measure, quote, install, balance and haul the old door away.

Look at the springs above the door — a clean gap in the coil means a broken spring and the door should not be forced. Otherwise check that the opener has power, the wall button works, the photo-eye sensors at floor level are aligned and clean, and the door is not locked or disengaged from the trolley. If the door is heavy to lift by hand, stop and call.

Yes, genuinely. A torsion spring holds enough stored energy to cause serious injury when it releases, and winding bars slip easily. This is one of the few garage door jobs where the DIY route is not worth the risk.

Usually a safety sensor issue or a down-force setting that is too sensitive. Sometimes it is a real obstruction, a worn roller binding in the track, or a door that has fallen out of balance. All four are quick to diagnose in person.