Commercial Garage Door Repair in Maple Valley, WA

Look at the springs above the door — a clean gap in the coil means a broken spring and the door should not be forced. Otherwise check that the opener has power, the wall button works, the photo-eye sensors at floor level are aligned and clean, and the door is not locked or disengaged from the trolley. If the door is heavy to lift by hand, stop and call.

Yes. Quarterly or biannual visits covering inspection, lubrication, hardware re-torque, tension checks and operator service, with priority response between visits.

Yes, genuinely. A torsion spring holds enough stored energy to cause serious injury when it releases, and winding bars slip easily. This is one of the few garage door jobs where the DIY route is not worth the risk.

It depends on the part that failed. A tune-up or sensor realignment sits at the low end, roller and cable work in the middle, and torsion spring replacement or a new opener at the higher end. You get a firm, itemised price in Maple Valley before any work begins, and that number does not move once the job starts.

Yes. We service rolling steel, coiling and sectional overhead doors for shops, warehouses, fleet bays and loading docks throughout Maple Valley, including high-cycle spring and operator upgrades and scheduled preventive maintenance.

Usually a safety sensor issue or a down-force setting that is too sensitive. Sometimes it is a real obstruction, a worn roller binding in the track, or a door that has fallen out of balance. All four are quick to diagnose in person.