Garage Door Spring Repair in Maple Valley, WA

Usually a safety sensor issue or a down-force setting that is too sensitive. Sometimes it is a real obstruction, a worn roller binding in the track, or a door that has fallen out of balance. All four are quick to diagnose in person.

It depends on the part that failed. A tune-up or sensor realignment sits at the low end, roller and cable work in the middle, and torsion spring replacement or a new opener at the higher end. You get a firm, itemised price in Maple Valley before any work begins, and that number does not move once the job starts.

Look at the springs above the door — a clean gap in the coil means a broken spring and the door should not be forced. Otherwise check that the opener has power, the wall button works, the photo-eye sensors at floor level are aligned and clean, and the door is not locked or disengaged from the trolley. If the door is heavy to lift by hand, stop and call.

Yes. Both springs have taken the same number of cycles, so the second is usually weeks or months behind the first. Replacing as a pair costs far less than paying for a second call-out.

A standard spring is rated around 10,000 cycles, which is roughly seven to ten years for an average household. Open and close the door four or more times a day and that drops sharply. High-cycle springs are worth the small upgrade if your door works hard.

Yes. We service rolling steel, coiling and sectional overhead doors for shops, warehouses, fleet bays and loading docks throughout Maple Valley, including high-cycle spring and operator upgrades and scheduled preventive maintenance.